Plunger Switch Removal And Replacement - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG

4.5.24 Plunger Switch Removal and Replacement

Removing and replacing the plunger switch requires access from both
the top and front of the range.
These instructions are for the plunger switch shown in Figure 125.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 125: Plunger Switch
1 Tabs (2) – press both to release plunger switch
1. First follow steps 1 through 8 of the Door Latch Removal and
Replacement procedure, starting on page 64.
2. [For small oven plunger switch only] Detach the two wire
connectors from the two wider blade terminals of the plunger
switch (there are four blade terminals on the plunger switch). See
Figure 126, page 67.
3. [For large oven plunger switch only] Detach the four wire
connectors from the four terminals on the plunger switch. See
Figure 123, page 66.
NOTE: It is always recommended to label and tag all wires, wire
connectors, and harnesses prior to disconnecting them so as to
correctly identify their connections/locations when re-assembling.
Alternatively, you can photograph prior to disconnecting (for
example, with your mobile phone).
58300000156573_ARA_EN_B
4. In order to remove the plunger switch, from inside the cavity press
the two metal tabs on the sides of the plunger switch (see Figure
125) as you pull the plunger switch outward from the front of the
range. You may need to pry the bezel of the plunger switch out
with a flat-blade screwdriver in order to pull it out (see Figure 127,
page 68).
5. Replace the plunger switch if needed.
Figure 126: Plunger Switch in Cavity (Small Oven of 48-Inch Model
Shown)
Page 67 of 119