Thermador PRL304EG Service Manual page 64

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
4. If obstructing access to the door latch access panel, remove the
burner support rail (with jet holder assemblies attached) by
following the steps in Removing the Burner Support Rail, page 24.
NOTE: Depending on the model range, if the door latch and/or
plunger switch is located under the griddle/grill you need you may
need to remove the griddle/grill first in order to gain access. See
Griddle Removal and Replacement, page 26 and Grill
Components – Removal and Replacement, page 32.
5. Remove and retain the single screw that holds the access panel to
the range chassis (see Figure 121).
6. Lift the access panel up, and detach its two tabs from the chassis
(see Figure 121, page 65).
7. Remove and retain the two T-20 screws under the front control
panel (see Figure 122).
8. Gently lift the latch out of the cavity (see Figure 123).
Figure 121: Door Latch Access Panel (Small Oven Access Panel
Shown)
1 Tabs (2)
2 Screw
58300000156573_ARA_EN_B
Figure 122: Door Latch, Screws, and Plunger Switch
1 T-20 screws (2)
2 Door latch
3 Plunger switch
Page 65 of 119