Five-Position Oven Function Selector - Removal And Replacement - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
5. From the back of the control panel, first make a note of how the
wires are connected to the oven temperature selector terminals,
and then remove the wire connectors from the terminals (see
Figure 94 and Figure 96 on page 51).
NOTE: It is always recommended to label and tag all wires, wire
connectors, and harnesses prior to disconnecting them, so as to
correctly identify their connections/locations when re-assembling.
Alternatively, you can photograph the wire connections prior to
disconnecting (for example, with your mobile phone).
6. At the front of the control panel, remove and retain the two screws
through the bezel that attach to the oven temperature selector
(see Figure 97), and then remove the bezel.
7. At the back of the control panel, remove the oven temperature
selector, and replace it if necessary.
Figure 97: Screw Locations on Bezel
1 Location of screws (2)
58300000156573_ARA_EN_B
4.5.11 Five-Position Oven Function Selector – Removal and
Replacement
The Five-Position Oven Function Selector switch is for the large oven
on 48-inch ranges only. Depending on the range model and FD
number, the Five-Position Oven Function Selector switch may or may
not be fastened with a clip-shaped bracket (see Figure 99).
NOTE: When installing the Five-Position Oven Function Selector,
make sure to attach the wire connector correctly onto all of the pins.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 98: Five-Position Oven Function Selector (Typical Models)
Figure 99: Front and Back of Five-Position Oven Function Selector
(Typical Model Shown with Retaining Bracket)
1 Retaining bracket
Page 52 of 119