Cisco Unified Ip Phone 8961, 9951, And 9971 Administration Guide For Cisco Unified Communications Manager - Cisco 9971 Administration Manual

Cisco IP Phone Web Page
Item
GARP Enabled
Video Capability
Enabled
Voice VLAN
Enabled
DSCP for Call
Control
DSCP for
Configuration
DSCP for Services
Security Mode
Web Access Enabled
Span to PC Port
PC VLAN
CDP on PC Port
CDP on SW Port
LLDP-MED: SW
Port
LLDP: PC Port

Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager

10.0
290
Description
Indicates whether the phone learns MAC addresses from Gratuitous ARP responses.
Indicates whether the phone can participate in video calls when it connects to an
appropriately equipped camera.
Indicates whether the phone allows a device that is attached to the PC port to access
the Voice VLAN.
DSCP IP classification for call control signaling.
DSCP IP classification for any phone configuration transfer.
DSCP IP classification for phone-based services.
Security mode that is set for the phone.
Indicates whether web access is enabled (Yes) or disabled (No) for the phone.
Indicates whether the phone forwards packets that are transmitted and received on
the network port to the access port.
VLAN that identifies and removes 802.1P/Q tags from packets that are sent to the
PC.
Indicates whether CDP is supported on the PC port (default is enabled).
When CDP is disabled in Cisco Unified Communications Manager, a warning is
displays to indicate that disabling CDP on the PC port prevents CVTA from working.
The current PC and switch port CDP values are shown in the Settings menu.
Indicates whether CDP support exists on the switch port (default is enabled).
Enable CDP on the switch port for VLAN assignment for the phone, power
negotiation, QoS management, and 802.1x security.
Enable CDP on the switch port when the phone connects to a Cisco switch.
When CDP is disabled in Cisco Unified Communications Manager, a warning is
presented, indicating that CDP should be disabled on the switch port only if the phone
connects to a non-Cisco switch.
The current PC and switch port CDP values are shown on the Settings menu.
Indicates whether Link Layer Discovery Protocol Media Endpoint Discovery
(LLDP-MED) is enabled on the switch port.
Indicates whether Link Layer Discovery Protocol (LLDP) is enabled on the PC port.