Cisco Unified Ip Phone 8961, 9951, And 9971 Administration Guide For Cisco Unified Communications Manager - Cisco 9971 Administration Manual

The following figure shows the steps for installing the bracket.
Figure 27: Bracket Installation
Step 2 Attach the phone bracket to the IP phone and key expansion assembly.
a) Detach the handset cord (and headset cord, if there is a headset), power cord, and any other attached cords
from the base of the phone
b) Remove the label covers that are conceal the screw holes.
c) Attach the phone bracket by inserting the tabs into the mounting tabs on the back of the phone. The phone
ports should be accessible through the holes in the bracket.
d) Secure the phone bracket to the IP phone with the machine screws using a #1 Philips-head screwdriver.
e) Thread the handset cord (and headset cord, if using one). Reattach the cords and seat them in the clips that
are incorporated into the phone body.
The headset and handset connectors should be accessible from outside the wall mount bracket.

Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0

Non-Lockable Wall Mount Components for Phone with Key Expansion Module
149