Cisco Unified Ip Phone 8961, 9951, And 9971 Administration Guide For Cisco Unified Communications Manager - Cisco 9971 Administration Manual

Non-Lockable Wall Mount Components for Phone with Key Expansion Module
Procedure
Step 1 Mount the wall bracket in the desired location. You can install the bracket over an Ethernet jack, or you can
run the Ethernet network cable to a nearby jack.
Note If the jack is to be placed behind the phone, the Ethernet jack must be flush to the wall or recessed.
a) Hold the bracket on the wall. See the following figure for the orientation of the wall bracket.
b) Use the level to ensure that the bracket is level and use a pencil to mark the screw holes.
c) Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the anchor
into the wall.
d) Screw the anchor clockwise into the wall until it is seated flush.
e) Use the included screws and a #2 Phillips-head screwdriver to attach the bracket to the wall.

Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager

10.0
148