Front And Rear Pto Shaft Control; Rear Pto Shaft - Shift Gear Lever Of Dependent And Independent Revolutions - Zetor FORTERRA HSX 120 Operator's Manual

FRONT AND REAR PTO SHAFT
CONTROL
Switches and controls of front and rear
PTO shaft control are located on the right
column of the cabin.
1. The control of the selection of rear
PTO shaft revolutions (P.T.O.)
2. The control of preselection of rate of
rear PTO shaft run
3. Rear PTO shaft switch
4. Front PTO shaft switch
DRIVE OF AGRICULTURAL MACHINERY
FH12N003f
REAR PTO SHAFT – SHIFT GEAR LEVER OF DEPENDENT AND INDEPENDENT
REVOLUTIONS
Gear shift lever of dependent and independent revolution of rear PTO shaft and is lo-
cated on the right side, next to the driver´s seat at the back.
PTO - Independent PTO shaft revolutions (number of revolutions is depend-
ent on the number of engine revolutions)
N - Neutral position
End-piece of rear PTO shaft can be freely spun around
PTO Dependent PTO shaft revolutions engaged (number and purpose of the
synchro -
revolutions is dependent on the engaged gear and the position of the
reversing lever)
91
FH12N002