Working With Pto; Control Of The Front And Rear Pto - Zetor PROXIMA POWER Z90 2012 Operator's Manual

WORKING WITH PTO

1. When working with the PTO make sure that all the covers are properly
attached.
2. After the end of the work always reassemble the PTO guard.
3. Always connect and disconnect the articulated shaft of the attached ma-
chine to and from the rear PTO of the tractor with the engine stopped,
PTO switched off and the lever of the dependent and independent PTO
speed shifted in the N - neutral position!
4. Always connect and disconnect the articulated shaft of the attached ma-
chine to and from the front PTO of the tractor with the engine stopped and
PTO switched off!
5. Any repairs or cleaning of parts of attached machines driven by the PTO
may only be carried out with the engine stopped, PTO switched off and
the lever of the dependent and independent PTO speed shifted in the N -
neutral position.
DRIVE OF AGRICULTURAL MACHINES
E351
98
E352a
CONTROL OF THE FRONT AND REAR
PTO
The PTO's are switched on (at the min.
engine speed of 1500 rpm) and off with t
he switches situated on the right pillar of
the cab. The switches are equipped with
mechanical locks (1) against accidental
activation. When using a switch, press
the lock downwards.
P - The switch controls the front PTO
Z - The switch controls the rear PTO
By pressing both the switches you will
activate both the PTO's (front and rear).
Activation of the PTO's is indicated by
the illuminated symbol on the switch.
X353