After Draining Oil; Replacement Of The Transmission Oil Cleaner Element With Hydraulic Pump Suction Filter; Insertion Piece Replacement Of The Oil Cleaner With Delivery Filter Of The Gearbox Switchboard - Zetor FORTERRA HSX 120 Operator's Manual

AFTER DRAINING OIL

1. Clean the magnet (it is part of the lid)
and the strainer element of the
suctioning filter (2)
2. After cleaning screw all the drain
screws back on.
3. Fill oil, start the engine and let it run
for approx. 2 minutes
4. After stopping of the engine and
stabilization of the oil level in the
gearbox check its quantity and fill up
oil to the upper edge of the dipstick
tab or if increased filling is necessary,
to the lower or upper mark of the
dipstick.
MAINTENANCE INSTRUCTIONS
FH12N078
REPLACEMENT OF THE
TRANSMISSION OIL CLEANER
ELEMENT WITH HYDRAULIC PUMP
SUCTION FILTER
The oil cleaner is placed on the left side
of the gearbox.
Before replacing the oil cleaner
element, place a suitable vessel
for dripping oil under the tractor.
1. Unscrew the body of the cleaner (1)
2. Replace the filtration element
3. Reassemble the body of the cleaner
F11N038
INSERTION PIECE REPLACEMENT OF
THE OIL CLEANER WITH DELIVERY
FILTER OF THE GEARBOX
SWITCHBOARD
Oil cleaner is placed on the left side of
the gearbox.
The cleaner clogging is signalized by a
control on dashboard lighting up.
Before replacing the insertion of the oil
cleaner, place a suitable vessel under
1. Unscrew the body of the cleaner (1)
2. Replace the insertion filter
3. Do the back assembly of the body of
183
the tractor for catching the drip-
ping oil.
the cleaner
FH12N055