Front Pto; Brake Fluid Replacement; Carbon Filter Installation Instructions - Zetor FORTERRA HSX 120 Operator's Manual

FRONT PTO

The inspection and filling plug of oil (1) is
situated on the front side of the front
PTO case.
The front PTO with the standard turning
direction is equipped with a hollow bolt of
the oil cooler hose instead of the inspec-
tion and filling plug. Perform the check
after removing the hollow bolt.
After unscrewing of the inspection
plug the oil level must reach the
bottom edge of the inspection
opening.
During the oil replacement the oil clean-
ing strainer (2) must be cleaned. The
cleaning strainer is accessible after the
disassembly of the locking ring and re-
moval of the cap.
MAINTENANCE INSTRUCTIONS
F206

BRAKE FLUID REPLACEMENT

The vessel is placed on the rights side
and is accessible after lifting the front
bonnet.
Keep the level of brake fluid in the range
of 3/4 of the content of the vessel (maxi-
mum height) to 1/2 of the vessel content
(minimum height of the level).
When handling brake liquid, keep
absolute cleanness. Check the
brake liquid level daily before
starting your work.
185
FH12N017
CARBON FILTER INSTALLATION
INSTRUCTIONS
1. Remove the old filter from the air duct
orifice in the place of its mounting.
2. Remove the protective package from
the new filter.
3. Insert the filter into the air duct orifice
in such a way to make the air flow
direction correspond to the flow
direction through
accordance with the arrow on the
filter. The entering air must first pass
through the white dust filtration layer.
4. Check proper sealing of the filter.
5. Secure the filter.
E13
the filter in