Rear Outlets Of The Outer Hydraulic Circuit; Front Outlets Of The Outer Hydraulic Circuit - Zetor FORTERRA HSX 120 Operator's Manual

REAR OUTLETS OF THE OUTER
HYDRAULIC CIRCUIT
In the tractor version that is not equipped
with the front outlets or the front three-
point hitch and that is equipped with
a - a three-section distributor the rear out-
lets are terminated with pressure
quick-couplers "1" to "6".
b - a two-section distributor the rear out-
lets are terminated with pressure
quick-couplers "1" to "4".
The third quick-coupler marked "0" is di-
rectly connected to the final drive hous-
ing and is designed for return oil from ex-
ternal hydraulic implements (e.g. from ro-
tational hydraulic motors, etc.).
HYDRAULIC SYSTEM
FH12N044
FRONT OUTLETS OF THE OUTER
HYDRAULIC CIRCUIT
They are installed on a panel in the right
front part of the tractor. Their installation
is bound to a three-section distributor.
They are designed for the control of fron-
tally attached adapters. The marking of
the outlets and their use is the same as
in the case of the rear outer outlets.
F168
couplers must not be connected at the
time of three-point hitch usage con-
nected because they are pressurized to-
gether like front three-point hitch!
After terminating the work with a front
three-point hitch for further usage of the
section with quick couplers 3 and 4 with
the connection of three-point hitch, it is
necessary to lift the arms of the front
three-point hitch to transporting position
and the lever of the cock of the front
three-point hitch in the "closed" position.
110
If the tractor is equipped with a
three-point hitch, the (F)(3)(4)(N)
lever is used for its control. Quick