Maintenance / Repair - ABB 265DS Operating Instruction

Maintenance / Repair

Pos: 25.1 /Überschriften/1/V - Z/Wartung / Reparatur @ 0\mod_1132065140479_3101.doc @ 3171
12 Maintenance / Repair
Pos: 25.2 /Wartung / Reparatur/Druck/Druckmessumformer/Druckmessumformer 265Dx, 265Vx/Wartung / Instandsetzung @ 17\mod_1201170223156_3101.doc @ 154103
If transmitters are used as intended under normal operating conditions, no maintenance is
required. It is sufficient to check the output signal at regular intervals (in accordance with the
operating conditions), as described in the instructions in the section "Operation". If deposits are
expected to accumulate, the measuring equipment should be cleaned on a regular basis, in
accordance with the operating conditions. Cleaning should ideally be carried out in a workshop.
Caution - Potential damage to parts
If a remote seal is mounted on the measuring equipment, it must not be removed.
Warning - General risks
Explosion-proof transmitters must be either repaired by the manufacturer or approved by a
certified expert following repair work. Observe the relevant safety precautions before, during,
and after repair work.
Only disassemble the transmitter to the extent necessary for cleaning, inspection, repairs, and
replacement of damaged components.
Returns
Defective transmitters sent to the repairs department must, wherever possible, be accompanied
by your own description of the fault and its underlying cause.
Important
Please use the form for returned products, provided in the Appendix.
This helps us to perform repairs quickly and without the need to contact you for further details.
Before you return the device, please clean it and pack it safely and securely. When ordering
spare parts or replacement devices, please quote the serial number (S/N) of the original device
as well as the year of manufacture (Yr.).
Address
ABB Automation GmbH
- Service Instruments -
Schillerstr. 72
D-32425 Minden
GERMANY
Spare parts:
Tel.: +49 (0) 571 830-1364
Fax: +49 (0) 571 830-1744
E-mail: parts-repair-minden@de.abb.com
Technical support:
Tel.: +49 (0) 180-5-222 580
Fax: +49 (0) 621 38 193 129 031
E-mail: automation.service@de.abb.com
Pos: 25.3 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830
78 265Dx, 265VS IM/265D/V-EN-02