Maintenance / Repair - ABB 265GS Operating Instruction

Maintenance / Repair

10 Maintenance / Repair
If pressure transmitters are used as intended under normal operating conditions, no
maintenance is required. It is sufficient to check the output signal at regular intervals (in
accordance with the operating conditions), as described in the instructions in the section
"Operation". If deposits are expected to accumulate, the measuring equipment should be
cleaned on a regular basis, in accordance with the operating conditions. Cleaning should ideally
be carried out in a workshop.
NOTICE - Potential damage to parts!
If a remote seal is mounted on the measuring equipment, it must not be removed.
WARNING - General dangers!
Explosion-proof transmitters must be either repaired by the manufacturer or approved by a
certified expert following repair work. The relevant safety precautions must be taken before,
during, and after repair work.
Only disassemble the transmitter to the extent necessary for cleaning, inspection, repairs, and
replacement of damaged components. The measuring equipment, either on its own or with a
direct mount remote seal, may only be repaired by the manufacturer.
Returns
Defective transmitters sent to the repairs department must, wherever possible, be accompanied
by your own description of the fault and its underlying cause.
IMPORTANT (NOTE)
Please use the form for returned products, provided in the Appendix.
This helps us to perform repairs quickly and without the need to contact you for further details.
Before you return the device, please clean it and pack it safely and securely. When ordering
spare parts or replacement devices, please quote the serial number (S/N) of the original device
as well as the year of manufacture (Yr.).
82 265Gx, 265Ax IM/265Gx/Ax-EN-07