Motor M2 - Electrolux IC44832 LF Service Manual

Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair

Motor M2 :

Checking
- Check the wiring.
- Check the condition of the 4 carbons in the motor.
Replacing
- Remove the protection cover from the feeding clamps guiding rail.
- Disconnect the supply wires from the motor.
- Remove the belt.
- Remove the motor driving pulley.
- Remove the motor from the bracket.
- Fit the new motor.
- Refit the parts in the reverse sequence.
Replacing the carbons
- Remove the motor from the machine's frames.
- Remove the plastic protection of the carbon using a screwdriver.
- Pull the carbon from its housing and fit a new one.
- Refit the parts in the reverse sequence.
1
4
04106016/GB
43-09
Feeding : Motion system
(electricity, steam, water, gas, compressed air...).
2
5
12
3
9