Repair; Diamms Settings; Service Option» Access - Electrolux IC44832 LF Service Manual

Service
Manual
Before any intervention it is essential to cut off all supply of the machine

Repair

Checking
- Check the wiring.
- Ensure contact between the two humidity sensors comb and check that the value
«Moisture» in «Service option» varies, otherwise the sensors comb are faulty.
Replacing
- Remove the reception vat on the feeding table (on FLF)
- Disconnect the wires.
- Remove the 2 sensors comb from the separator bar.
- Fit the new sensors comb and connect them on their respective terminals.
- Perform an adjustment as described above.

DIaMMS settings

In order to have a working correctly of DIAMMS system after replacing the control display, it is
necessary to set the P1 and P2 potentiometer and to check the parameter «Value of Length»
«Service Option» access
The machine has been set in the factory to specific values of heating, folding, temperature,
ironing speed, operating language, etc. These values and specifications can be set in the
«Service Option» menu.
The parameters must always correspond to the specific type of machine.
• Remove the left side frame of the machine.
• Press on the push-button «BP4» on the board n°1 of the control panel using an insulated
tool.
04106016/GB
43-09
DIaMMS kit
(electricity, steam, water, gas, compressed air...).
board n°1
board n°2
control panel
Bp4
15
5