Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair
push button Bp3 and Bp201 :
Checking the BP3 push button
- Check the wiring.
- Using a multi-meter, check the push button's continuity when it is actuated.
Replacing
- Remove the protection cover from the clamp guiding rail.
- Disconnect the cables from the push button.
- Remove the push button and fit a new one.
- Refit the parts in the reverse sequence.
Contactors KM201 and KM202 :
Checking
- Check the wiring.
- Supply manually the coil of the contactors and check that the contacts stick. Otherwise,
the contactors are faulty.
Replacing
- Remove the left cover from the machine.
- Disconnect all the cables connected to the A2 feeder interconnection board.
- Change the A2 feeder interconnection board.
- Refit the parts in the reverse sequence.
04106016/GB
43-09
Feeding : Motion system
(electricity, steam, water, gas, compressed air...).
12
13