Service
Manual
Before any intervention it is essential to cut off all supply of the machine
Repair
Ventilation motor M1 :
Checking
- Check the wiring.
- Power on the machine and check that the M1 motor is running. Otherwise, the motor is
faulty.
Replacing
- Remove the right cover on the machine.
- Remove the extensible hose.
- Separate the turbine from the motor.
- Remove the motor from its bracket.
- Fit the new motor.
- Refit the parts in the reverse sequence.
Contactor KM1 :
Checking
- Check the wiring.
- Start the machine and check that the contacts on the contactor stick or whether the motor
is running. Otherwise, the contactor is faulty.
Replacing
- Remove the left cover on the machine.
- Disconnect all the wires connected to the interconnection base plate.
- Change the interconnection base plate.
- Refit the parts in the reverse sequence.
04106016/GB
43-09
Ventilation
(electricity, steam, water, gas, compressed air...).
8
5