Table 3-19: Sip Interface Table Parameters; Figure 3-157: Sip Interface Table - AudioCodes mediapack MP-500 User Manual

SIP User's Manual
To configure the SIP Interface table:
1. Open the 'SIP Interface Table' page (Configuration tab > Protocol Configuration
menu > SBC submenu > SIP Interface Table).
2. Add an entry and then configure it according to the table below.
3. Click the Apply button to save your changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 237.
Parameter
Network Interface
[SIPInterface_NetworkInterface]
Application Type
[SIPInterface_ApplicationType]
UDP Port
[SIPInterface_UDPPort]
TCP Port
[SIPInterface_TCPPort]
Version 5.8
Figure 3-157: SIP Interface Table Page

Table 3-19: SIP Interface Table Parameters

Corresponding network interface (IPv4) name, as configured in
the 'Multiple Interface' table (InterfaceTable).
The default is "Not Configured".
Note: The value of this parameter must be exactly as configured
in the 'Multiple Interface' table ('Interface Name' field), except for
the WAN interface (which does not appear in the 'Multiple
Interface' table), in which case, the value must be set to the
string "WAN".
Determines the application type associated with the SIP
Interface.
[0] GW/IP2IP (default) = IP-to-IP routing application and
regular gateway functionality
[1] SAS = Stand-Alone Survivability (SAS) application
[2] SBC = Session Border Control (SBC) application
Determines the listening and source UDP port.
The valid range is 1 to 65534. The default is 5060.
Note: This port must be outside of the RTP port range.
Determines the listening TCP port.
The valid range is 1 to 65534. The default is 5060.
Note: This port must be outside of the RTP port range.
183
3. Web-Based Management
Description
October 2009