Factory Setting Of The Inverter Control - Siemens SIMATIC ET 200pro Original Instructions Manual
Distributed i/o system low voltage converter
Hide thumbs
Also See for SIMATIC ET 200pro:
- Operating instructions manual (545 pages) ,
- Quick manual (260 pages) ,
- Operating instruction (146 pages)
Table of Contents
Advertisement
6.2.1
Factory setting of the inverter control
Switching the motor on and off
The inverter is set in the factory so that after it has been switched on, the motor accelerates
up to its speed setpoint in 10 seconds (referred to 1500 rpm). After it has been switched off,
the motor also brakes with a ramp-down time of 10 seconds.
Figure 6-1
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
Switching on and switching off the motor and reversing in the factory setting
Commissioning
6.2 Preparing for commissioning
69
Advertisement
Table of Contents
