Siemens SIMATIC ET 200pro Original Instructions Manual page 76

Commissioning
6.5 Basic commissioning
11. Input the correct Motor Speed from the motor rating
12. Select to run or disable Motor Data Identification func-
13. Set the Minimum Speed at which the attached motor
14. Set the Ramp Up time in seconds.
15. Set the Ramp Down time in seconds.
76
plate.
This value is given in RPM.
tion.
This function, if active, will not start until the first run
command is given to the Inverter.
should run.
This is the time the Inverter/motor system will take from
being given the run command, to reaching the selected
motor speed.
This is the time the Inverter/motor system will take from
being given the OFF1 command, for the motor to reach
a standstill.
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB