Installation; Setting The Profibus Address - Siemens SIMATIC ET 200M Manual

Installation

Introduction
In this chapter we will show you how to carry out the mechanical configuration, and
prepare and install the ET 200M components.
To set up an ET 200M, you must take into account the configuration of the
electrical installation. Make sure you also read Chapter 5, entitled "Wiring".
Chapter Overview
Section
4.1 Mechanical Configuration
4.2 Installation
4.3 Connecting the Bus Connector
4.4 Connecting the Fiber-Optic Cable to the IM 153-2 FO
4.5

Setting the PROFIBUS Address

Open Modules
The modules of an ET 200M are open equipment. That means you can only install
the ET 200M in housings, cabinets or electrical operating areas. These housings,
cabinets and electrical operating areas should only be accessible by means of a
key or a special tool. Only trained or authorized personnel should have access to
the housings, cabinets or electrical operating areas.
Distributed I/O Device ET 200M
EWA-4NEB780600602-06
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Contents
4
Page
4-2
4-8
4-17
4-18
4-20
4-1