Description; Components For Assembling A Frequency Converter - Siemens SIMATIC ET 200pro Original Instructions Manual

Description

Use for the intended purpose
The inverter described in this manual is a device for controlling an induction motor. The
inverter is designed for installation in electrical installations or machines.
It has been approved for industrial and commercial use on industrial networks. Additional
measures have to be taken when connected to public grids.
The technical specifications and information about connection conditions are indicated on
the rating plate and in the operating instructions.
Description
The SIMATIC ET 200pro FC-2 is a converter that is completely embedded in the distributed
I/O system SIMATIC ET 200pro.
3.1

Components for assembling a frequency converter

General information
The following section shows two configuration examples for frequency converters in the
ET 200pro distributed I/O system.
You can find additional general information on the ET 200pro distributed I/O system in the
Internet underET 200pro distributed I/O system
(https://support.industry.siemens.com/cs/de/en/ps/man)
To select components for a ET 200pro distributed I/O system, we recommend the "SIMATIC
ET 200 Configurator".
The ET 200pro system contains a large number of components which the user can combine
according to his needs.
The minimum configuration of a frequency converter requires the following components:
● a rack,
● a complete interface module including a bus terminating module (in the scope of supply of
the IM),
● the bus module of the frequency converter and the frequency converter itself.
The components described below are examples and represent the minimum configuration of
a standard frequency converter with the safety function STO.
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2015, FW V4.7.3, A5E34257324B AB
3
21