Configuration - In Setup Program Only; Customer-Specific Linearization - JUMO mTRON T Operating Manual

NOTE!
The parameters described in this section can only be configured with the setup program.
7.1

Customer-specific linearization

You can use the customer-specific linearization to create a customized linearization character-
istic line for analog inputs. This characteristic line is used for all analog inputs for which the cor-
responding linearization has been selected in the configuration.
Customer-specific linearization can only be programmed with the setup program. Two proce-
dures are available for this (type of linearization: grid points or formula).
NOTE!
It is possible to create different characteristic lines with grid points and formula. The relevant
point, however, is which kind of linearization is currently selected when the dialog box is
closed by clicking "OK". The corresponding characteristic line is then used in the module.
Signalfluss
(1)
(1) Measured value
(2) Offset (physical)
(3) Measured value monitoring of standard sig-
nals (limits acc. to NAMUR)
(4) Linearization (grid points / formula)
Grid points: Domain monitoring (measured
values)
Formula: Co-domain monitoring (linearized
values) with respect to the measuring range
(configuration parameter: Measuring range
start, Measuring range end)
7 Configuration – in setup program only
>>>>
+
<<<<
(2) (3)
y
x
(4)
(5) Offset (standardized)
(6) Linearized value monitoring with respect to
the scale (configuration parameter: Scale
start, Scale end)
(7) Linearized value
>>>>
+
<<<<
(5) (6)
(7)
57