8 Online parameters
8.1.4
LED test
Setup dialog
Parameter
Parameter
S LED
1 LED
NOTE!
An LED maintains the set status until a new status is set or until the "LED test" dialog window
is closed.
66
Selection/settings
To test the LED, click the required status
to select it (OFF, red, or green).
After selection, the LED enters the cho-
sen status immediately.
To test the LED, click the required status
(OFF or yellow) to select it.
After selection, the LED enters the cho-
sen status immediately.
Description
This function is used to test the electrical
function of the "S" LED (Status).
This function is used to test the electrical
function of LED "1".