JUMO mTRON T Operating Manual page 38

6 Configuration
Parameter
Scale start
?
Scale end
?
TAG number
Unit
Offset type
?
Offset
?
Filter time con-
stant
?
Cold junction
Ext. reference
temp.
Resistance Ra or
Ro
?
Resistance Rs or
Rx
?
Resistance Re
?
Linearization
Linearization must be selected according to the sensor (measuring probe).
The predefined linearizations can be supplemented with customer-specific linearization.
 Chapter 7.1 "Customer-specific linearization", page 57
38
Selection/settings
Factory setting depends on sensor and linearization.
-99999 to +99999
Factory setting depends on sensor and linearization.
-99999 to +99999
7 characters
5 characters (%)
Type of measured value offset
Standardized
Physical
-100 to 0 to +100
As of system version 04:
-99999 to 0 to +99999
0 s to 0.6 s to 100 s
Selection of cold junction (for thermocouple)
Internal Pt100
External constant
-20 to 0 to +200
0 Ω to 4000 Ω
6 Ω to 1000 Ω to 4000 Ω
0 Ω to 4000 Ω
Description
Start value of display range
End value of display range
Identification marking (documentation in
PLC)
Unit for numerical representation of
measured value
Offset of standardized measured value
(after linearization)
Offset of physical measured value
(before linearization)
Correction value
Time constant for adjusting the digital
input filter (0 s = filter off)
Internal Pt100 temperature probe
Constant cold junction temperature
Cold junction temperatures (for thermo-
couple and constant cold junction tem-
perature)
For Resistance transmitter:
Resistance Ra between sliding contact
(S) and start (A), if the sliding contact is
positioned at the start.
For Resistance/potentiometer:
Offset resistance Ro
For Resistance transmitter:
Resistance range Rs of sliding contact
For Resistance/potentiometer:
Shifting resistance range Rx
For Resistance transmitter:
Resistance Re between sliding contact
(S) and end (E), if the sliding contact is
positioned at the end.