JUMO mTRON T Operating Manual page 37

Parameter Selection/settings
Linearization Available options and factory settings depend on the measuring probe selected
?
Linear
Pt50
Pt100
Pt500
Pt1000
Pt100J
Pt100G
KTY
Cu50
Cu100
Ni100
NiCr-CuNi_E
Cu-CuNi_T
Fe-CuNi_J
Cu_CuNi_U
Fe-CuNi_L
NiCr-Ni_K
Pt10Rh-Pt_S
Pt13Rh-Pt_R
Pt30Rh-Pt6Rh_B
NiCrSi-NiSi_N
W5Re-W26Re_C
W3Re-W25Re_D
W3Re-W26Re
Chromel-Copel
Chromel-Alumel
Platinel II
Customer-specific
Measuring range Factory setting depends on sensor and linearization.
start
-99999 to +99999
?
Measuring range Factory setting depends on sensor and linearization.
end
-99999 to +99999
?
6 Configuration
Description
GOST 6651-94
DIN EN 60751
DIN EN 60751
DIN EN 60751
JIS 1604
GOST 6651-94
Type KTY11-6
GOST 6651-94
GOST 6651-94
DIN EN 60751
DIN EN 60584
DIN EN 60584
DIN EN 60584
DIN EN 60584
DIN EN 60584
DIN EN 60584
DIN EN 60584
DIN EN 60584
GOST 8.585-2001
GOST 8.585-2001
Customer-specific linearization using
grid points (pairs of values) or 4th order
polynomial
Start value of the measuring range (for
resistance transmitter, standard signal,
and potentiometer) to detect out of
range
End value of measuring range (see
above) to detect out of range
37