JUMO mTRON T Operating Manual page 20

Measuring, control, and automation system analog input module 4-channel

Hide thumbs Also See for mTRON T:

Table of Contents

3 Installation

Dismounting, using the example of a multichannel controller module 705010

Removing the multichannel controller module from the DIN rail

Procedure:

Step

(E5)

Activity

Fully release the end bracket (D) using a screwdriver (D1), press upward from below, pivot

toward the front, and remove from the DIN rail.

Note: The end bracket does not need to be removed from the DIN rail if there is sufficient

space to the side to move it at least 20 mm to the right.

Move the cover (C) to the right (C2) until the side contacts of the neighboring module are

exposed. Then release the cover at the bottom using a screwdriver, press upward, and

remove from the DIN rail.

Note: The cover does not need to be removed from the DIN rail if there is sufficient space

to the side to move it at least 20 mm to the right.

(A)

(A4)

(E)

(A8)

(F7)

(F)

(B)

(B3)

(C2)

(A)

(A6)

(D1)

Table of Contents