At+ Instruction Set Description; Description Of At+ Instruction - Waveshare WIFI232-B2 User Manual

WIFI232-B2 User Manual
Note: WIIF232 module can works as AP or STA, users have to use different AT+
Instruction to set WIFI parameters when module works as AP or STA mode.
5.2

AT+ Instruction Set Description

5.2.1 Description of AT+ Instruction

5.2.1.1 AT+E
Function: Enable/Disable echo function.
Format:
AT+E<CR>
+ok<CR><LF><CR><LF>
After switch to configuration mode from transparent transmission mode, the echo
function is opened by default. The first time you use this command is to close the
function.
5.2.1.2 AT+ENTM
Function: Set module enter transparent transmission mode
Format:
AT+ENTM<CR>
+ok<CR><LF><CR><LF>
With this command, the module switch to transparent transmission mode form
configuration mode. You can input "+++" and confirmation code to back to
configuration mode again.
5.2.1.3 AT+ENTP
Function: Set/Query network protocol parameters
Format:
Query Operation
AT+NETP<CR>
+ok=<protocol, CS, port, IP><CR><LF><CR><LF>
Set Operation:
AT+NETP=<protocol, CS, port, IP><CR>
+ok<CR><LF><CR>LF>
Parameters:
58 / 102