Switch To Configuration Mode - Waveshare WIFI232-B2 User Manual

WIFI232-B2 User Manual

4.9.14 Switch to Configuration Mode

The steps to switch to configuration mode from transparent transmission mode:
➢ UART input "+++", after module receives "+++", it will feedback "a" as
confirmation.
➢ UART input "a" for confirming, after module receives "a", it will feedback "+ok"
to go into AT+ instruction set configuration mode.
Notes:
When user input "+++" and confirmation "a", the UART port will not echo as above
figure. User need to input "+++" and "a" as fast as possible to reduce the probability
that module error to enter configuration mode when it in working mode.
In configuration mode, user can use AT+ instruction on UART port to setting,
inquiry or restart the module. User can also use AT+ instruction to back to transparent
transmission mode.
Figure 40 Switch to Configuration Mode
51 / 102