Waveshare WIFI232-B2 User Manual page 68

WIFI232-B2 User Manual
Set Operation:
AT+WANN=<mode, address, mask, gateway><CR>
+ok<CR><LF><CR><LF>
Parameters:

mode
 static: static IP
 DHCP: Dynamic IP

address: IP address of WAN port

mask: subnet mask of WAN port

gateway: gateway address of WAN port
5.2.1.21 AT+LANN
Function: Set/Query LAN port setting (available at AP mode)
Format:
Query Operation:
AT+LANN<CR>
+ok=<address, mask><CR><LF><CR><LF>
Set Operation:
AT+LANN=<address, mask><CR>
+ok<CR><LF><CR><LF>
Parameters:

address: IP address of LAN port

mask: subnet mask of LAN port
Note: AT+WANN check the WAN port address, and the AT+LANN check the LAN port
of module. You can set these two IP address on the same network segment, otherwise
the module will work abnormally.
5.2.1.22 AT+TCPTO
Function: Set/Query TCP timeout
Format:
68 / 102