Ethernet Interface Communication; Wifi232 Ethernet Interface Networking (Ap) - Waveshare WIFI232-B2 User Manual

WIFI232-B2 User Manual
also active and permit phone/PAD to connect through TCPB, then phone/PAD can
control user device and setting the module parameters.
The advantages of AP+STA mode are:
 Users can easily set and track user device through Phone/PAD and not change
the original network setting
 Users can easily set module's parameters through WIFi when module works as
AP+STA mode
AP+STA Mode Setting:
AP+STA mode need serial AT command to enable as follows:
 AF+FAPSTA=on, Enable AP+STA mode
 Then configure the module that, keep AP interface active when work in STA
mode
AP+STA Mode Notes:
Wen user enable AT+STA function, the STA port need to keep connecting with
other router (AP), or it will scan the AP frequently, which will affect AP port function and
may cause some data loss.
So, if user confirm STA port cannot connect with AP at some time, user can disable
the STA scan through the following command:
 AT+STTC=on/off, on: scan AP. off: not scan AP. (This command is invalided
after re-powert)
 AT+FSTTC=on/off. This command is valid after re-power.
4.4

Ethernet Interface Communication

WIFI232 module provides one 100M Ethernet interface. With this Ethernet interface,
user can easily realize the three interface (WIFI, UART and Ethernet) intercommunication
and networking. WIFI2332 module can be configured as Bridge Mode or Router Mode
base on different networking technology.
Notes: As the Ethernet mode will increase additional consumption, so it is default
closed。 If you need this function, please use AT_FEPHY=on to open it and RELD
cannot change this. For different application, WIFI232 need version switch via
commands (such as following description of N-Ver and Z-Ver). With command
AT+FVER=n to switch to N-Ver and with command AT+FVER=z to switch to Z-ver.
4.4.1

WIFI232 Ethernet Interface Networking (AP)

28 / 102