Waveshare WIFI232-B2 User Manual page 7

WIFI232-B2 User Manual
•
Encryption mode: open, none;
•
UART: 57600, 8, 1, None;
•
Network parameters: TCP, Sever, 8899, 10.10.100.254;
•
IP: 10.10.100.254
We just need to follow the corresponding parameters to set the network
communication parameters. With the setting, we could make serial <-->WIFI
communication. The steps are as below:
1. Open the test software TCP232-test;
2. COM Setting area (left):
Choose COM port which has been used to connect the module, there is COM 10,
choose baud rate to 57600, it is the default baud rate of WIFI module. Then click Open.
3. Net Settings area (right);
Choose TCP client mode, Server IP write 10.10.100.2554. It is the WIFI default IP
address, Server port set 8899, it is the default listen Port of the WIFI module. Click
Connect to link to the module.
Now we could test send data between RS232 and WIFI.
COM port to WIFI: PC RS232->Module RS232->Module WIFI->PC WIFI.
7 / 102