Table of Contents
Advertisement
WIFI232-B2 User Manual
WIFI232 module works as AP and the center of this network. All devices' IP address
in this network shall use the same network segment with WIFI232 and they can
intercommunication with this method.
4.4.2 WIFI232 Ethernet Interface Networking (STA N-Ver)
Figure 21 WIFI232 Ethernet Interface Networking (STA N-Ver)
WIFI232 module works as STA (Software is N-Version), and module set as router
mode. When module connect to AP, it will get wireless port IP address from AP (For
example: 192.168.1.101). At the same time, module also from a subnet (Default
10.10.100.254) and all devices connected to module Ethernet interface will get assigned
IP address (For example: 10.10.100.101). So as shown, PC1 at internal subnet can initiate
a connection to PC2 (For WIFI232 works as router mode), but PC2 cannot active initiate
a connection to PC1.
4.4.3 WIFI232 Ethernet Interface Networking (STA, Z-Ver)
Figure 20 WIFI232 Ethernet Interface Networking (AP)
29 / 102
Advertisement
Table of Contents
