Table of Contents
Advertisement
WIFI232-B2 User Manual
check for
4
check for
5
password
6
check
Example:
Data from phone to module (HEX): FF 00 0F 02 00 54 45 53 54 31 0D 0A 31 32 33 34 35
36 CE
Data from module to phone (HEX): FF 00 03 82 01 01 87
Explanation:
The phone set setting command to module, set the SSID to "TEST1", password is
"123456". The information response from module is that: the network which SSID is
"TEST1" is exist, and the form of password is correct.
4.8.8 Ready Pin Signal Indication
According to the factory setting, the nReady signal have two statuses:
Status 1: High before module finish booting, Low after finishing boot. User devices can
inquiry this signal to check whether the module have finished booting.
Status 2: High before module finish booting, output Heartbeat signal after finishing
boot. The wave pattern of Heartbeat signal is 0.5Hz square wave which duty ratio is 1:1.
User devices ccan query this signal to judge if modules active "live" or need to reboot.
When module switches to command mode, it will output "0", which used to distinguish
work mode and command mode.
4.8.9 Similar RFC2217 Auto-adapt Baud Rate Function
RFC2217 is a standard protocol that user ethernet to change the parameter of
ports. This module supports a protocol which is similar to RFC2217, which has same
function as RFC2217 but much simply. Could use AT command to open the auto-adapt
baud rate function:
AT+AABR=on
This command take effect immediately without reboot. Once reboot, the change of this
command is invalided and restore to default value.
RFC2217 protocol description:
1
SSID
1
1
Table 7 Fast access WI-FI Response for Setting
check of SSID. If the SSID is exist,
check value is 0x01, otherwise is
0x00
check of password. if the form of
password is correct, the check
value is 0x01, otherwise is 0x00
Sum of bytes from head byte (not
contained) to check byte (not
contained)
39 / 102
Advertisement
Table of Contents
