Table of Contents
Advertisement
WIFI232-B2 User Manual
Figure 22 WIFI232 Ethernet Interface Networking (STA, Z-Ver)
For above networking, WIFI232 module works as STA (Firmware is Z-Version), and
module configured as bridge mode. When module connect to AP. all devices connected
to module Ethernet interface will get assigned IP addressed IP address from AP (For
example: 192.168.1.101). For module works as bridge mode, it can be treated as a
transparent device and PC1, PC2 can communicate without any limit. But in this
networking, WIFI232 module needs assign a static LAN IP address (For example:
192.168.1.10) if module also communication with AP or configuration through web
page.
4.5
WI-FI parameter setting
4.5.1 Auto-Frequency Function
When module works as STA, WIFI232 will adjust its wireless channel to keep the
same channel with associated AP and connect in.
When module works as AP and WIFI32 enable Auto-frequency function, then when
module boot up, it will select the best wireless channel based on surrounding
environment
4.5.2 Security
WIFi232 module supports multiple wireless encryption mechanisms, and enables to
protect the security of user's data transmission, the mechanisms include:
WEP
WPA-PSK/TKIP
WPA-PSK/AES
WPS2-PSK/TKIP
30 / 102
Advertisement
Table of Contents
