Switch To Configuration Mode; At+ Instruction Set Overview - Waveshare WIFI232 User Manual

WAVESHARE ELECTRONICS
In configuration mode, user can setting the module through AT+ instruction set, which cover all
web page setting function.

5.2.1.1 Switch to Configuration Mode

Two steps to finish switching from transparent transmission mode to configuration mode.
 UART input "+++", after module receive "+++", and feedback "a" as confirmation.
 UART input "a", after module receive "a" and feedback "+ok" to go into AT+
instruction set configuration mode.
Notes:
1. When user input "+++" (No "Enter" key required), the UART port will display feedback
information "a", and not display input information"+++" as above UART display.
2. Any other input or wro ng step to UART port will cause the module still works as original mode
(transparent transmission).

5.2.2 AT+ Instruction Set Overview

User can input AT+ Instruction through hyper terminal or other serial debug terminal, also can
program the AT+ Instruction to script. User can also input "AT+H" to list all AT+ Instruction and
description to start.
Figure 38 Switch to Configuration Mode
Page 45 of 81
WIFI232 User Manual