WAVESHARE ELECTRONICS
The phone PDA send setting command to module, SSID is set to "TEST1", password is set to
"123456". The response from module is that the "TEST1" Wi-Fi network exist, the form of
password is correct.
4.8Palmodic Signal
Base on selected factory default setting, "nReady" signal can have two output statuses:
Status One: The module will output "0" after normal boot up. This signal used to judge if
module finish boot up and ready for application.
Status Two: The module will output "Palmodic Signal" after normal boot up.The palmodic
signal is 0.5Hz square wave with dutyfactor 1:1. User can query this signal to judge if
moduleis active "live" or need to re-boot. When module switches to command mode, it will
output "0", which used to distinguish work mode and command mode.
4.9 Parameters Configuration
WIFI232 module supports two methods to configuration parameters: Web Accessing and
AT+instruction set.
Web accessing means users can configure parameters through built-in webpage. When WIFI232
module connected to wireless network, parameters configuration is done on a PC connected to
the same wireless network. AT+instruction set configuration means user configure parameters
through serial interface command. Refer to "AT+instruction set" chapter for more detail.
4.10
Firmware Upgrade
WIFI232 module supports firmware upgrade online.
Page 36 of 81
WIFI232 User Manual