Table of Contents
Advertisement
WAVESHARE ELECTRONICS
WIFI232 User Manual
Figure 21 WIFI232 Ethernet Interface Networking (As STA, N-Ver)
WIFI232 module works as STA (Software is N-Version), and module set as router mode. When
module connect to AP, it will get wireless port IP address from AP (For example: 192.168.1.100).
At the same time, module also form a subnet (Default 10.10.100.254) and all devices connected
to module Ethernet interface will get assigned IP address (For example: 10.10.100.101).So as
shown, PC1 at internal subnet can initiate a connection to PC2 (For WIFI232 works as router
mode), but PC2 can‟t active initiate a connection to PC1.
4.4.3 WIFI232 Ethernet Interface Networking (As STA, Z-Ver)
Figure 22 WIFI232 Ethernet Interface Networking (As STA, Z-Ver)
For above networking, WIFI232 module works as STA（Firmware is Z-Version）,and module
configured as bridge mode. When module connect to AP, all devices connected to module
Ethernet interface will get assigned IP address from AP (For example: 192.168.1.101).For module
works as bridge mode, it can be treated as a transparent device and PC1, PC2 can communicate
without any limit. But in this networking, WIFI232 module needs assign a static LAN IP address
(For example: 192.168.1.10) if module also needs communication with AP or configuration
through web page.
4.5 WI-FI parameter setting
Page 29 of 81
Advertisement
Table of Contents
