Ethernet Interface Communication; Wifi232 Ethernet Interface Networking (As Ap); Wifi232 Ethernet Interface Networking (As Sta, N-Ver) - Waveshare WIFI232 User Manual

WAVESHARE ELECTRONICS
WIFI232 User Manual

4.4 Ethernet Interface Communication

WIFI232 module provides one 100M Ethernet interface. With this Ethernet interface, user can
easily realize the three interface (WiFi, UART, and Ethernet) intercommunication and networking.
WIFI232 module can configured as Bridge Mode or Router Mode base on different networking
technology.
Notes: As the Ethernet mode will increase additional consumption, so it is default closed. If you
need this function, pls use AT+FEPHY=on to open it and RELD can‟t change this. For different
application, WIFI232 need version switch via commands (such as following description of N-ver
and Z-ver). With command AT+FVER=n to switch to N-ver and with command AT+FVER=z to
switch to Z-ver.

4.4.1 WIFI232 Ethernet Interface Networking (As AP)

Figure 20 WIFI232 Ethernet Interface Networking (As AP)
WIFI232 module works as AP and also the center of this network. All devices‟ IP address in this
network shall use the same network segment with WIFI232 and they can ntercommunication with
this method.

4.4.2 WIFI232 Ethernet Interface Networking (As STA, N-Ver)

Page 28 of 81