Format - Logicube Falcon-NEO User Manual

Logicube Falcon -Neo User's Manual
®
•
•

5.3.2.3 Format

Formats the Destination using the EXT4, NTFS, exFAT, or FAT32
file system with or without encryption. To format the drive (with
or without encryption) tap the Settings icon.
The Falcon-NEO will check the Destination drive
for formatting prior to being used as a Destination
or Repository for Imaging using Drive to File, File
to File, Partition to File, or Net Traffic to File. If
the drive has not been formatted by the Falcon-
NEO, the Destination drive must be formatted
using the Falcon-NEO prior to being used as a
Destination for Imaging using either mode above.
Tap this icon to set the Falcon-NEO to format the drive (with or
without encryption). The following settings are available:
• Format – When set to ON, the Falcon-NEO will format
the Destination drive with or without encryption. The
drive will be formatted with the user's choice of file
system (EXT4, NTFS, exFAT, or FAT32). When set to OFF,
the Falcon-NEO will not format or encrypt the selected
drive.
TYPES OF OPERATIONS
VALUE – Instructs the Falcon-NEO to
use the specified hexadecimal value to
be written for the pass. The values can
range anywhere from 00 to FF.
VERIFY – Select YES to verify each wipe
pass value the Falcon-NEO performs.
When Verify is set to YES,
the total time to wipe the
drive will double.
61