8: Updating/Loading/Re-Loading The Falcon-Neo Software; Updating/Loading/Re-Loading Software - Introduction; Updating/Loading/Re-Loading Software Instructions; From Network (Over The Internet) - Logicube Falcon-NEO User Manual

8: Updating/Loading/Re-loading the Falcon-NEO Software

8.0 Updating/Loading/Re-loading Software – Introduction
New and improved software will be released from time to time and will always be available on the
Falcon-NEO support page. Browse to http://www.logicube.com. Point your mouse to Tech
Support and select Product Knowledge Base or go directly to
http://www.logicube.com/knowledge/forensic-falcon-neo.

8.1 Updating/Loading/Re-loading Software Instructions

There are two methods of how to update the Falcon-NEO software:
A. FROM NETWORK – Over the Internet through a network connection
B. FROM USB DRIVE – Through a software file download onto a USB drive flash.
The actual software installation will take about 5 minutes. If FROM
NETWORK was chosen, the total time can exceed 10 to 20 minutes
(or longer) depending on Internet speeds and Internet traffic.
The most up-to-date instructions on updating the
software can be found on the Falcon-NEO's support page.

8.1.1 From Network (Over the Internet)

The Falcon-NEO software can be updated/re-installed by connecting the Falcon-
NEO to a network with internet access.
1.
2.
3.
Logicube Falcon -NEO User's Manual
®
Connect the Falcon-NEO to a network with internet access and turn the
Falcon-NEO on.
From the main menu on the Falcon-NEO, locate and tap the Software
Updates icon on the left side.
Select From Network. The Falcon will check for software on Logicube's
server. After a few seconds, one of the following messages will appear:
Newer version available – This message will appear if there is a
•
newer software version found. Tap the OK icon to continue.
Up to date – This message will appear if the software version
•
found is the same as the version currently installed. Tap the OK
icon to continue.
107