Step-By-Step Instructions; Using Previously Encrypted Destination Drives - Logicube Falcon-NEO User Manual

7.1.1 Step-by-step Instructions

1.
2.
3.
4.
5.
6.
7.
8.

7.1.2 Using previously encrypted Destination drives

If a previously encrypted Destination drive is going to be used and the Falcon-
NEO has been turned off since the last time the encrypted drive was used, the
encryption settings must be set with the same encryption settings previously
used before connecting the drive.
1.
2.
Logicube Falcon -Neo User's Manual
®
Select System Settings from the types of operation on the left side.
Tap the Encryption tab.
Set the Cipher Mode, Cipher, IV Generation, and Password.
Select Wipe from the types of operation on the left side.
Tap the Destination icon and select the Destination drive to be
formatted and encrypted.
Tap the Settings icon.
Tap the Format Settings icon to change the Format setting.
a. Set Format to ON.
b. Select the desired File System (EXT4, NTFS, exFAT, or FAT32).
c. Set Encryption to ON. When finished, tap the OK icon.
Tap the Start icon to start the wipe task. The Falcon-NEO will format the
selected drive(s) with encryption.
If the same encryption settings are commonly used, the
encryption settings and configuration can be saved as a profile,
so they do not have to be entered manually all the time.
Make sure the previously encrypted Destination drive is not connected,
then turn the Falcon-NEO on.
From the main menu, select System Settings from the types of
operations on the left side.
DRIVE ENCRYPTION & DECRYPTION
95