Connecting Via Ssh; Zero Configuration Networking (Zeroconf) - Logicube Falcon-NEO User Manual

9.2.2 Connecting via SSH

Connecting to the Falcon-NEO via SSH (Secure Shell) is very similar to connecting
via Telnet. Since Windows does not have a built-in SSH client, a third party SSH
client will need to be downloaded and installed to connect via SSH. For
instructions and support on how to use third party SSH clients, please contact the
SSH client's manufacturer.
1.
2.
3.
4.
5.
The Falcon-NEO can now be configured or managed via the command line
interface.

9.3 Zero Configuration Networking (Zeroconf)

The Falcon-NEO has the capabilities for Zero Configuration Networking (Zeroconf). Zeroconf
allows devices to automatically create a usable computer network based on the Internet Protocol
Suite (TCP/IP). For example, when the Falcon-NEO is connected (using a network cable) directly to
a Windows based computer that is DHCP enabled, both the Falcon-NEO and the Windows based
computer will automatically configure themselves to be seen by each other using TCP/IP with a
169.254.x.x IP address configuration.
Logicube Falcon -Neo User's Manual
®
Using one of the RJ45 connectors in the back of the Falcon-NEO, connect
the Falcon-NEO to a network.
Turn the Falcon-NEO on and allow it to boot up completely.
Open the SSH client and select an SSH connection.
Connect to the Falcon-NEO either by IP address or by hostname. The
name of the Falcon-NEO will be falcon-XXXXXX where XXXXXX is the 6-
digit serial number of the Falcon-NEO).
On some Operating Systems, the Falcon-NEO will
need to be accessed by opening falcon-XXXXXX.local.
Login with the username "it" (without the quotes) and the password "it"
(without the quotes). A command prompt should appear in the SSH
window.
Use the it login in step 5. It is not recommended to
use the logicube account login without consulting
with Logicube Technical Support prior to use.
REMOTE OPERATION
112