User Account Passwords - Logicube Falcon-NEO User Manual

Logicube Falcon -Neo User's Manual
®
for more information on how to connect to the
Falcon-NEO using the CLI.
Once connected to the Command Line Interface
(CLI):
1. Login with the username "it" (without
2. From the main prompt, type command,
3. Type config then press the enter key.
4. Type db list then press the enter key.
5. Type db load initial.db then press the
6. Type db list again and there should be
7. Turn the Falcon-NEO off using the
8. Turn the Falcon-NEO on. When the

5.10.2.2 User Account Passwords

The Falcon-NEO comes with two built-in user accounts:
logicube
•
TYPES OF OPERATIONS
This method will only work if the
INITIAL.DB profile does not have
a Config Lock Key saved. If the
INITIAL.DB has a Config Lock
Key configured, and the
password was forgotten, contact
Tech Support assistance.
the quotes) and the password "it"
(without the quotes).
then press the enter key.
This will show a list of profiles (or
databases) saved. The Falcon-NEO has
one default profile called initial.db. Any
profiles added by users will appear in
this list. The db that shows an asterisk (*)
before the name is the current database
or configuration being loaded each time
the Falcon-NEO is turned on.
Enter key to load the default database.
There should be a response showing
"Command (DbManagement)
Successful".
an asterisk (*) on initial.db.
power button, then close the Telnet/SSH
application.
Falcon-NEO boots up, it will load the
default configuration (INITIAL.DB).
82