Starting The Imaging Operation - Logicube Falcon-NEO User Manual

4.5 Starting the Imaging Operation

Once all the settings and options have been selected or set, tap the Start icon to begin the
imaging task. A confirmation screen will appear. Tap the Yes icon to continue.
A progress bar will appear at the bottom of the screen showing the bytes processed, the rate
(speed), elapsed time, time remaining, and any read errors.
When finished, the status will show "COMPLETED". It is recommended to tap Reset Task to reset
the task, so the drive bays properly reset and not show as being used or assigned for other tasks.
he number of bytes shown on the progress bar is not the actual
size of the drive. This is the actual data being processed. When
'Verify' is set to "Yes", the reported number will double in size.
The Falcon-NEO can automatically span to two (or more)
Destination drives when using Drive to File mode (DD, E01, EX01,
or DMG). When the Destination drive is full and the remaining data
to be imaged will not fit, Falcon-NEO will prompt for another drive.
Information on Drive Spanning can be found in
Logicube Falcon -Neo User's Manual
®
Section 3.1.6.
IMAGING
48