G94: Feed Per Minute (Non-Synchronized Feed) - Mitsubishi Electric MELSEC iQ-R16MTCPU Programming Manual
Motion controller, g-code control, melsec iq-r series
Hide thumbs
Also See for MELSEC iQ-R16MTCPU:
- Programming manual (482 pages) ,
- Programming manual (124 pages) ,
- Programming manual (216 pages)
Table of Contents
Advertisement
G94: Feed per minute (non-synchronized feed)
The commands from the block are commanded at a feed speed of one minute [mm/min].
Code
Program
G94
G94
Processing details
• By commanding G94, the values that follow F can be commanded at a feed speed of one minute [mm/min].
• The G94 command is modal. G94 mode is valid when transitioning to G-code control or after reset.
5 G-CODE CONTROL PROGRAMS
5.6 G-Code
5
161
Advertisement
Table of Contents
