OPTIMUM
M A S C H I N E N - G E R M A N Y
4.1.2 Restarting
Before restarting run a safety check.
"Safety check" on page 91
WARNING!
Before starting the lathe, you must check that there is no danger for persons and that
theis not damaged.
4.2
Inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions. For this reason, all the intervals are only valid for the authorised conditions.
Interval
Where?
Start of work,
after every
maintenance or
repair work
Start of work,
after every
maintenance or
repair work
Start of work,
after every
maintenance or
repair work
GB
TU2506 | TU2506V | TU2807 | TU2807V
Page 146
What?
How?
"Safety check" on page 91
Lubricate all slideways.
Slightly lubricate the change gears and lead screw with
Lubricating
lithium-based grease.
Check the oil level in the sight glass of the feed gear. It
must reach at least the centre of the sight glass.
If necessary, fill up to the reference mark with Mobilgear
627 or equivalent oil.
visual inspection
Original operating instructions
Sight glass
Img.4-1: Oil sight glass feed gear
Version 1.0.1
Maintenance
2014-05-16