Img.3-28: Workpiece between points: Tailstock offset Vr
3.18
Tailstock sleeve
The tailstock sleeve is used to hold the tools (bits, lathe centres, etc.)
The sleeve of the tailstock can a drill chuck used for the recording of drilling and countersinking
tools are set.
Clamp the required tool in the tailstock sleeve.
Use the hand wheel to move the sleeve back and forth.
Clamp the sleeve with the clamping lever.
Use the adjustment and / or setting the [mm] - scale on the sleeve.
3.19
Clamping a workpiece into the three jaw chuck
When the workpiece is being clamped unprofessionally, there is a risk of injury as the work-
piece may fly off or the jaws may break. The following examples do not show all possible situa-
tions of danger.
wrong
Version 1.0.1
2014-05-16
Clamping length too long,
overhang too long.
Clamping diameter too
large.
Workpiece is too heavy
and clamping grade too
short.
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
right
Additional support over
center or rest.
Use
larger lathe.
Support over center,
enlarges clamping grade.
Enlarged clamping grades
are not available for this
three-jaw chuck.
Possibly use larger lathe.
TU2506 | TU2506V | TU2807 | TU2807V
GB
Page 125