General Parameters - Siemens SINUMERIK 808D User Manual

Note
In step 2, a detailed parameter description of each function can be found in the relevant sections.
4.4.2

General parameters

General parameters
When parameterizing the particular functions, among others, the following general parameters are available:
Parameter
Function name
Tool (T)
Compensation (D)
Direction of spindle
rotation
Feed value (F)
Type of feedrate
Spindle speed (S)
Spindle type
Coolant
Machining
Position
Reference
Note
Additional parameter descriptions for the individual functions are provided in the corresponding chapters.
Programming and Operating Manual (Manual Machine Plus (MM+), Turning)
01/2017
Press this hardkey if you want to interrupt the machining operation. The selected direction of
the spindle rotation continues to be activated.
By pressing this hardkey, "JOG" operating mode is automatically changed, that is, you can
traverse the axes manually. By continuing executing a cycle start , the interruption point is
approached again and execution of the program is continued.
7. If machining was terminated (for example, completed), the execution screen can be exited
using this softkey.
Description
Number of the selected function
Tool number
Tool offset number
Toggle field for spindle direction of rotation (clockwise/counterclockwise)
Feed value
Toggle field for feed type (mm/min or mm/rev)
Spindle speed value
Toggle field for spindle type (rev/min)
Toogle field for coolant function (coolant OFF/coolant ON)
The type of machining operation can be selected in this toggle field. The following options are
available: complete machining, roughing only, and finishing only.
The machining direction can be selected with the first toggle field.
The following options are available: outside right, inside right, and outside left. The diagram dis-
played on the screen changes to indicate which option is selected.
The cutting direction can be selected with the second toggle field.
Available selection: infeed in the longitudinal axis and roughing cut in the transverse axis (face), or
roughing cut in the longitudinal axis and infeed in the transverse axis (long.). The current selection
is shown in the form of a diagram on the screen.
Contour start position in the longitudinal axis (absolute position of the Z axis).
31