74
2.
Press this softkey and a list with all tools created in the control system will be displayed.
The fields "T" and "D" contain the active tool and the active cutting edge number, respec-
tively.
3.
To select the tool, enter the tool number and the cutting edge number in the input fields "T"
and "D", respectively.
Alternatively, perform the following operations to select the tool:
Use this key to change to the list and position the cursor on the appropriate tool.
Then press this key to confirm the selection.
The selected tool is copied into the "T" input field.
4.
If the tick is set in the field "G75" (approach fixed point), the controller travels to a stored
fixed point before the tool change.
5.
Press this softkey.
Programming and Operating Manual (Manual Machine Plus (MM+), Turning)
01/2017